If You do not receive an email after registering ,check your spam folder in Your mailbox .
Auto registration in the queue from 5 minutes to 12 hours
If you have problems logging on the forum, write your message in the technical support forum
Registration is not required
Technical support Forum
Auto registration in the queue from 5 minutes to 12 hours
If you have problems logging on the forum, write your message in the technical support forum
Registration is not required
Technical support Forum
Proposals-Wishes-bugs k 200
- ChrisHusky
- Участник
- Posts: 69
- Joined: 13.05.2016
- Reputation: 46 (+46/−0)
- Loyalty: 0 (+0/−0)
- With us: 7 years 11 months
- Location: Фуррятино
- Flag:
- Contact:
Есть проблема с крашеными дисками, а именно - на одной из сторон видно пятно:
Это не тень от хаба: если сдать назад, то это темное пятно тоже начнет перемещаться:
На алюминиевых дисках это заметно меньше, на хромированных не заметно вовсе. С видео не особо дружу, так что снял уж как смог, более-менее должно быть понятно: https://youtu.be/F1olomH-60k
Это не тень от хаба: если сдать назад, то это темное пятно тоже начнет перемещаться:
На алюминиевых дисках это заметно меньше, на хромированных не заметно вовсе. С видео не особо дружу, так что снял уж как смог, более-менее должно быть понятно: https://youtu.be/F1olomH-60k
- Kiwimike7
- VIP
- Posts: 30
- Joined: 29.06.2016
- Reputation: 4 (+4/−0)
- Loyalty: 0 (+0/−0)
- With us: 7 years 9 months
- Flag:
K200 UPDATE
Have tried the truck on a clean profile with no other mods running, and still get the same issue with the air pressure.
Cheers
Mike
Cheers
Mike
- V8Bolle
- VIP
- Posts: 28
- Joined: 01.04.2017
- Age: 62
- Reputation: 8 (+8/−0)
- Loyalty: 0 (+0/−0)
- With us: 7 years
- Location: Rostock
- Flag:
transmission
DE
Wäre es möglich, die Getriebe-Datei im mod-Teil1 unterzubringen? Bei allen LKW?
Die Getriebe-Datei im Teil1 kann ich bearbeiten, wie beim Mack und T908.
Beim K200 und WS4800 ist das leider nicht möglich, weil sich bei beiden die Getriebe-Datei in einem verschlüsselten Teil befindet.
Ich habe jetzt herausgefunden, wie das so funktioniert und habe mir für den Mack ein 12-Gang-Getriebe an meine Vorlieben angepasst.
Das Ergebnis ist deutlich mehr Spielspass für mich.
Erklärung:
Ich fahre gerne untertourig, schalte aber im Stadtverkehr nicht so gerne alle Gänge durch.
Da ich nur manuell (sequentiell) schalte, passt für mich kein angebotenes Getriebe so richtig.
Jetzt aber habe ich beim Anfahren den passenden Gang schon nach einem Schaltvorgang, da die unteren Gänge viel weiter gespreizt sind.
Die oberen Gänge liegen näher beieinander, sodass ich in den Bergen immer die richtige Drehzahl habe.
In den weiten amerikanischen Ebenen kann ich mit 1250/min dahinrollen.
Der 720 PS Mack V8 hat genügend Kraft dafür.
Und so weiter...
Es wäre schön, wenn man derartige Anpassungen bei allen eurer LKW machen könnte.
EN
Would it be possible to accommodate the transmission file in the mod part1? On all trucks?
The gear file in part1 I can edit, as with the Mack and T908.
With the K200 and WS4800 is unfortunately not possible, because with both the transmission file is in an encrypted part.
I have now figured out how this works so I have adapted for the Mack a 12-speed transmission to my preferences.
The result is much more fun for me.
Statement:
I like to drive with little engine speed, but do not like to drive all the gears in the city traffic.
Since I switch only manually (sequential), does not fit for me offered gear so correctly.
Now, however, I have the appropriate gear at the start after a gear shift, since the lower gears are spread a lot more.
The upper gears are closer together, so I always have the right speed in the mountains.
In the wide American plains I can roll with 1250 / min.
The 720 hp Mack V8 has enough power for it.
And so on ...
It would be nice if you could make such adjustments on all your trucks.
best regards
Bolle
Wäre es möglich, die Getriebe-Datei im mod-Teil1 unterzubringen? Bei allen LKW?
Die Getriebe-Datei im Teil1 kann ich bearbeiten, wie beim Mack und T908.
Beim K200 und WS4800 ist das leider nicht möglich, weil sich bei beiden die Getriebe-Datei in einem verschlüsselten Teil befindet.
Ich habe jetzt herausgefunden, wie das so funktioniert und habe mir für den Mack ein 12-Gang-Getriebe an meine Vorlieben angepasst.
Das Ergebnis ist deutlich mehr Spielspass für mich.
Erklärung:
Ich fahre gerne untertourig, schalte aber im Stadtverkehr nicht so gerne alle Gänge durch.
Da ich nur manuell (sequentiell) schalte, passt für mich kein angebotenes Getriebe so richtig.
Jetzt aber habe ich beim Anfahren den passenden Gang schon nach einem Schaltvorgang, da die unteren Gänge viel weiter gespreizt sind.
Die oberen Gänge liegen näher beieinander, sodass ich in den Bergen immer die richtige Drehzahl habe.
In den weiten amerikanischen Ebenen kann ich mit 1250/min dahinrollen.
Der 720 PS Mack V8 hat genügend Kraft dafür.
Und so weiter...
Es wäre schön, wenn man derartige Anpassungen bei allen eurer LKW machen könnte.
EN
Would it be possible to accommodate the transmission file in the mod part1? On all trucks?
The gear file in part1 I can edit, as with the Mack and T908.
With the K200 and WS4800 is unfortunately not possible, because with both the transmission file is in an encrypted part.
I have now figured out how this works so I have adapted for the Mack a 12-speed transmission to my preferences.
The result is much more fun for me.
Statement:
I like to drive with little engine speed, but do not like to drive all the gears in the city traffic.
Since I switch only manually (sequential), does not fit for me offered gear so correctly.
Now, however, I have the appropriate gear at the start after a gear shift, since the lower gears are spread a lot more.
The upper gears are closer together, so I always have the right speed in the mountains.
In the wide American plains I can roll with 1250 / min.
The 720 hp Mack V8 has enough power for it.
And so on ...
It would be nice if you could make such adjustments on all your trucks.
best regards
Bolle
Excuse my bad English!
Bolle
Bolle
- Kiwimike7
- VIP
- Posts: 30
- Joined: 29.06.2016
- Reputation: 4 (+4/−0)
- Loyalty: 0 (+0/−0)
- With us: 7 years 9 months
- Flag:
Air Pressure
Hi I see in the latest update that the air pressure problem that I raised in April still hasn't been fixed. Any ideas when it might be?
Cheers
Mike
Cheers
Mike
- spinner
- VIP
- Posts: 17
- Joined: 10.04.2016
- Reputation: 3 (+3/−0)
- Loyalty: 6 (+6/−0)
- With us: 8 years
- Flag:
willy1962 wrote:my wish for the k200 is a possibility for lights on the bullbar.
now I`m using the lights from the K108.
that means I need Always to install both mods.
or just a seperate lightpack that can be used on all of the RTA trucks ?
I'm using this https://ets2.lt/en/hella-auxiliary-light-pack-v-2-0-by-abasstreppas/ in both ATS and ETS2 with no problems. Shown in the pic are the Hella Jumbos.
Who is online
Users browsing this forum: 4 guests